Profile for Victor F (victor)

  • OFFLINE
  • Rank: Administrator
  • Register Date: 21 Feb 2013
  • Last Visit Date: 28 May 2019
  • Time Zone: GMT -8:00
  • Local Time: 03:01
  • Posts: 28
  • Profile Views: 953
  • Karma: 0
  • Location: Unknown
  • Gender: Unknown
  • Birthdate: Unknown

Signature

Posts

Posts

emo
The part numbers are there. Just click on Store in top menu, Parts. Below the headline is the link to parts.
??? Part numbers ???
Category: Suggestion Box
emo
If no bolt, the carburetor is glued by epoxy. Heat it up slightly and the epoxy will melt. Then remove the part.
Ame Carb Removal
emo
Everything is interchangeable - it is the same company, just a different name. The AME and Big Mig difference is the cylinders only.
Parts intterchangeab ...
emo
Just heat up the crankcase under the carburetor slightly with a heat gun. The carb is held by epoxy glue, which melts.
Adding throttle carb ...
emo
Just measure the inside opening. The standard head is 9mm, the turbo head is 10mm
How to determin whic ...
emo
There is no need to change a glow plug if it works. I use SIG Champion fuel and it works great.
What kind of fuel Ni ...
emo
If I were you, I would post this question here:

www.rcuniverse.com/forum/glow-engines-11...ine-glow-engine.html
nv gx 040
emo
I would get a cover plate with a pressure fitting (part #101005). It has a smaller nipple and provides a more consistent pressure than the muffler.
.061 Start Up proble ...
emo
I would try a different prop size, for example 12x4. Each prop size requires different carburetor tuning.
New GX40 Gasoline en ...
emo
Could post a video flying it? Thanks
Lite Machines flies ...
emo
Not bad at all. But I especially liked the landing :-)
Maiden flight of my ...
emo
Both numbers mean the same thing - the engine's displacement. 10 - for 1 cubic centimeter, 61 - for 0.061 cubic inches
Number stamp on the ...
emo
It is Revlite. To convert to diesel just get a diesel head, but you will need ether - nothing else will work.
I own an unused NV . ...
emo
Well done!
My Brodak Baby Flite ...
emo
The backplates for AME and Big Mig are the same size. The only difference is the cylinder ports.
Radial mount for a B ...
emo
It is castor oil. All instructions are in the top menu (Support)
Cold break in.
emo
Can you post a picture, please?
40AX BB Transfer Por ...
emo
Make sure you get the compression right. Read an article in the top Support menu.
Hello, My first post
emo
Nicely done!
My Brodak Baby Flite ...
emo
I wouldn't worry about the wrist pin - it is hard pressed into the piston.
Big Mig .061 - what ...
More
Time to create page: 0.42 seconds
kac1968imagedsplay0803tjac

Member Login