Welcome,
Guest
|
|
|
This is first start up on the gx I'm hving trouble getting started &
running--as per starting steps prime engine by hand connect glow turn with elec starter nothing happens --make sure plug lites up OK --close H speed needle turn the prop & yes I get a crack --open high speed needle 2 turns re prim spin spin with elec st nothing open high speed needle to 2.5 turns spin prop fuel spits out ex no start--look at plug flooded--! open throttle all the way spin prop to clean out fuel start all over anther time this is many time of adj needle falve down& out no pops no burble nothing--! I have Q on low end screw setting were should it be--this one is out 2 turns |
|
|
Hi If anyone Is Interested in my post on having trouble geting my mw
GX40 running properley I'm addmitting this being my fault not the engine It simpley boils down to not having a fully charged up Glow Driver--!! |
|
|
If I were you, I would post this question here:
www.rcuniverse.com/forum/glow-engines-11...ine-glow-engine.html |
|
|
Sounds like he's got it worked out after getting the glow driver charged. Turbo plugs require a bit more juice than a standard plug. So a low driver won't get it done.
|
|
|