nv gx 040
(1 viewing) (1) Guest
1/2A Airplane Engines 049-074
  • Page:
  • 1

TOPIC: nv gx 040

nv gx 040 9 years, 10 months ago #288

  • gdsikes
This is first start up on the gx I'm hving trouble getting started &
running--as per starting steps prime engine by hand connect glow
turn with elec starter nothing happens --make sure plug lites up OK
--close H speed needle turn the prop & yes I get a crack --open high
speed needle 2 turns re prim spin spin with elec st nothing open high
speed needle to 2.5 turns spin prop fuel spits out ex no start--look
at plug flooded--! open throttle all the way spin prop to clean out fuel
start all over anther time this is many time of adj needle falve down&
out no pops no burble nothing--! I have Q on low end screw setting were should it be--this one is out 2 turns

Re: nv gx 040 --Hard to start-- 9 years, 10 months ago #289

  • gdsikes
Hi If anyone Is Interested in my post on having trouble geting my mw
GX40 running properley I'm addmitting this being my fault not the engine
It simpley boils down to not having a fully charged up Glow Driver--!!

Re: nv gx 040 9 years, 10 months ago #290

  • victor
  • OFFLINE
  • Administrator
  • Posts: 28
  • Karma: 0
If I were you, I would post this question here:

www.rcuniverse.com/forum/glow-engines-11...ine-glow-engine.html

Re: nv gx 040 9 years, 10 months ago #291

  • hllywdb
  • OFFLINE
  • Junior Boarder
  • Posts: 27
  • Karma: 0
Sounds like he's got it worked out after getting the glow driver charged. Turbo plugs require a bit more juice than a standard plug. So a low driver won't get it done.
  • Page:
  • 1
Time to create page: 0.20 seconds
kac1968imagedsplay0803tjac

Member Login